Epson Stylus Pro 4900 User Manual page 9

Epson Stylus Pro 4900/4910
F
Paper eject support
Support smooth ejection of the printed paper by raising the supports when printing on plain roll paper and when
the optional SpectroProofer is installed. U
G
Front manual feeder
Feed paper into this slot when printing on cut sheets that are 0.8 mm thick or thicker. U
Thick Paper" on page 40
H
Cartridge cover (right)
Open when replacing ink cartridges or Maintenance Box 1.
"Replacing Ink Cartridges" on page 120
U
"Replacing Maintenance Box 1" on page 121
U
I
Maintenance Box 1
Container for collecting waste ink.
J
Ink cartridges
Install ink cartridges on the left and right for a total of 11 colors. Ink cartridge order U
page 14
K
Print head
Fires ink via high density nozzles while moving left and right to print.
Do not move the print head by hand.
L
Control panel
"Control panel" on page 13
U
M
Alert lamp
Lit or flashing when an error or warning occurs in the printer.
On : An error occurred. Check the contents of the error on the control panel's screen.
Flashing : An ink or paper low warning occurred. You can specify for which consumable this warning
Off : No error.
N
Printer cover
Open when loading thick paper, cleaning the inside of the printer, or removing jammed paper. Normally closed
when using the printer.
O
Rear manual feeder
User's Guide
Introduction
"Loading roll paper" on page 29
should occur. The factory setting is Off (no warning). U
page 160
9
"Loading and Ejecting
"Screen View" on
"Maintenance Mode List" on