Epson Stylus Pro 4900 User Manual page 30

Epson Stylus Pro 4900/4910
D
Hold with the gray flange (fixed) on the right,
place both sides of the spindle into the spindle
holder on the printer.
Match the colors of the spindle holder to the
colors on the end of the spindle.
Note:
If the spindle is set in the wrong direction, paper is
not fed correctly.
E
Press the Y button on the control panel.
Insert paper until message on LCD panel is
changed. is displayed on the screen.
F
Insert the leading edge of the roll paper in the roll
paper feeder.
When inserting, make sure not to fold the edge
and remove any slack.
User's Guide
Basic Operations
30
G
Feed the paper.
When Auto Roll Feeding is On
When the paper is inserted a little, the screen
display changes to Press the Y button.
Check that the screen display has changed, and
then press the Y button to automatically feed the
paper to the start position.
When Auto Roll Feeding is Off
Insert the paper (so that the edge of the paper
comes out of the front manual feeder) until the
screen display changes.
Check that the screen display has changed, and
then press the Y button to automatically feed the
paper to the start position.
H
Close the roll paper cover.
I
Check the media type.
Are these settings OK? is displayed on the
screen, and the media type currently specified on
the printer is displayed.
When roll paper with a barcode is loaded, the
confirmation message is not displayed as the
barcode is read automatically and the settings are
made automatically. Go to step 10.
When the displayed media type and the loaded
media type match, press the d/u buttons to
select YES, and then press the Z button.
If you want to change the media type, select NO
and then press the Z button. When the Paper
Type menu is displayed, select the category
depending on the loaded media type, and then
press the r button. Select the media type, and
then press the Z button.