YASKAWA SI-S3/V Series Installation Manual page 6

1 Preface and Safety
For the drive setup, refer to one of the documentation listed below.
STOP
V1000
Freq Reference : (Hz)
FWD / REV Sel :
Output Freq : (Hz)
Output Current : (A)
(V)
Selected Monitor :
Monitor :
Verify :
SetUpGuide :
Parameter Set :
Auto-Tuning
:
WARNING
Risk of electric shock.
Read manual before installing.
Wait 5 minutes for capacitor discharge after
disconnecting power supply.
To conform to requirements, make sure
to ground the supply neutral for 400V class.
Risque de décharge
AVERTISSEMENT
électrique.
Lire le manuel avant l'installation.
Attendre 5 minutes après la coupure de l'alimentation,
pour permettre la décharge des condensateurs.
Pour répondre aux exigences , s assurer que le
neutre soit relié à la terre, pour la série 400V.
STOP
T1000V
Freq Reference : (Hz)
FWD / REV Sel :
(Hz)
Output Freq :
Output Current : (A)
Selected Monitor : (V)
Monitor :
Verify
:
SetUpGuide :
Parameter Set :
Auto-Tuning :
WARNING
Risk of electric shock.
Read manual before installing.
Wait 5 minutes for capacitor discharge after
disconnecting power supply.
To conform to requirements, make sure
to ground the supply neutral for 400V class.
Risque de décharge
AVERTISSEMENT
électrique.
Lire le manuel avant l'installation.
Attendre 5 minutes après la coupure de l'alimentation,
pour permettre la décharge des condensateurs.
Pour répondre aux exigences , s assurer que le
neutre soit relié à la terre, pour la série 400V.
◆
Terms
Note: Indicates supplementary information that Yaskawa highly recommends be followed, even
though equipment may not be at risk.
Drive:
CANopen Option:
6
Yaskawa Drive (V1000)
Yaskawa AC Drive-V1000
Technical Manual
Yaskawa AC Drive-V1000
Quick Start Guide
Yaskawa Drive (T1000V)
Yaskawa AC Drive-T1000V
Technical Manual
Yaskawa AC Drive-T1000V
Safety Precautions
• Yaskawa AC Drive-V1000 Series
• Yaskawa AC Drive-T1000V Series
Yaskawa AC Drive 1000-Series Option CANopen (SI-S3/V, SI-S3/T)
YASKAWA ELECTRIC TOBP C730600 24D 1000-Series Option SI-S3/V, SI-S3/T Installation Manual
This manual describes installation, wiring, operation
procedures, functions, troubleshooting, maintenance,
and inspections to perform before operation.
To obtain instruction manuals for Yaskawa products
access these sites:
Europe: http//www.yaskawa.eu.com
Japan: http//www.e-mechatronics.com
Other areas: contact a Yaskawa representative
This guide is packaged together with the product. It
contains basic information required to install and
wire the drive. This guide provides basic
programming and simple set-up and adjustment.
This manual describes installation, wiring, operation
procedures, functions, troubleshooting, maintenance,
and inspections to perform before operation.
To obtain this manual, contact the local Yaskawa
sales office or the nearest Yaskawa representative.
This guide is packaged together with the product.
Covers safety precautions, areas to check upon
receiving your new T1000V, and standards
compliance.