Avg. Meas - Konica Minolta CR-10 Plus Instruction Manual

Instrument Settings

Avg. Meas.

— Confi gure as necessary —
Sets the number of measurements to perform when averaging measurements.
After setting the number of averaging measurements and pressing the measuring button
that many times, an average value from the obtained data will be displayed as the
measurement.
Memo If the number of averaging measurements is changed while performing average
measurement, the measured data will be cleared. (Target information will not be
cleared.)
1
Go to the "Setting" screen or the "Measure" screen.
or
2
Select "None" in the "Preset" settings area.
3
Select "Avg" under "Avg. Meas.", and click the box for entering the
count.
4
Enter the desired number.
The numeric pad will be displayed. Use this pad to enter the information. (2–10)
Memo Only the numeric pad can be used to input values.
5
Click "Enter" on the numeric pad.
Memo If a measurement fails during averaging measurement, the measurement can be
redone over until the number of measurements reaches "0".
(Cont.)
Instrument Menu Customization
1 2 3
Setting
Initial Setting Setting
● None Average measurement will not be performed.
The set number of measurements will be performed,
Avg and the average will be displayed.
Avg. Meas. Cnt 2–10
4 5
Setting
49