Table of Contents
Advertisement
Points to Remember
Icon Displays (Status indicator icons/Measurement
setting icons)
1. 2. 3. 4. 5.
6.
7.
8.
9. 10.
Turning ON/OFF Buzzer Sounds and the LED Lamp
Display
When shipped from the factory, the buzzer sound and READY lamp are set to ON.
However, these settings can be changed using the supplied PC application. For how to
confi gure these settings, read the information regarding turning the PC application
environment settings buzzer ON/OFF (Page E-57) and regarding the display LED
(READY lamp) display (Page E-58).
(Cont.)
1. Battery status/USB power display
2. LED (READY lamp) OFF display
3. Buzzer mute display
4. Save the data to the instrument.
5. USB connection status
6. Clock
7. Tolerance setting display
8. Average measurement count
9. Preset setting display
10. Target mask setting display
None
Shows that the remaining battery power is suffi cient.
Shows that the remaining battery level is low. Replace the batteries.
The system will fail if the batteries are not replaced immediately.
1.
(The power will turn off automatically 5 seconds after the display
appears.)
Power is being supplied through the USB cable.
2.
LED OFF (*Displayed when set to OFF from the PC application.)
3.
Buzzer mute (*Displayed when set to OFF from the PC application.)
4.
Measurement data is being saved to the instrument.
Shows that the instrument is attached to a PC.
5.
Shows that the instrument is attached to a printer.
6.
20:36
Time setting
Displayed when tolerance settings have been confi gured.
7.
The set tolerance is shown to the right of this mark.
Displayed when average measurement settings have been
8.
confi gured.
The set averaging count is shown to the right side of this mark.
Setting A, B, or C (preset setting name)
9.
When not displayed, the preset settings have not been confi gured.
Mask setting (MAV fi xed)
10.
Mask setting (SAV fi xed)
20
Advertisement
Table of Contents
