Konica Minolta CR-10 Plus Instruction Manual page 77

Memory Errors
4
Check whether the USB cable is connected or if there is suffi cient
battery power remaining.
5
Select "Yes" and confi rm.
MENU/OK
or 
Notes System recovery will not be possible if the power supply is turned off
during recovery. Make sure the cable is connected to USB bus power or the
AC adapter as the power source.
Memo Recovery will not be performed if "No" is selected. A message that reads,
"Measurement can be performed, but data cannot be saved to the instrument."
will be displayed. Press the MENU/OK key to confi rm the message.
6
"Recovering memory." will be displayed, and the
recovery process will begin (required time:
approx. 10 minutes).
Once memory recovery is complete, one of the following
messages noting success or failure will be displayed.
<Memory recovery successful>
7
Click "OK".
MENU/OK
(Cont.)
Recovering
memory.
Please wait.
Memory
recovery
successful.
Memory
recovery
successfully
finished.
OK
<Memory recovery failed>
Click "OK".
Notes If this message is displayed, contact a KONICA
MINOLTA-authorized service facility.
10:00
10:00
77
10:00
Memory
recovery
failed.
OK