Operating Modes - Fresenius Medical Care 2008K Troubleshooting Manual

How to Enter Dialysis Program:
a) Plug the connector(s) into concentrate and turn the
machine on. Allow the Start-Up ("Select Program") screen
(1) to appear.
b) Select the 'Dialysis' button to call the Dialysate ("Select
Concentrate") screen (2).
c) Select the 'Conc' button (2). A list of your concentrates
appears.
d) Using the panel's arrow (or +/-) keypads, select the
concentrate that is connected to the machine.
e) Press the 'CONFIRM' key. The machine is now preparing
dialysate i.e. in Dialysis program.
f) Select the 'Home' tab at the bottom of the screen to call
the 'Home' screen (3). NOTE: The "CONFIRM
Concentrate" screen can be called at any time by
selecting the 'Dialysate' tab at the bottom of the screen.
Auto flow ("a500", "a800") Function
Selecting Dialysate flow rates greater than 800 ml/min
may enable the auto flow function (1.5x or 2x)
depending on software. At these settings Dialysate
flow rates depend on blood flow rates and the
[Dialysate Flow] window displays a preceeding "a"
(example "a500"). Do NOT enable auto flow while
troubleshooting!
How to Enter a Cleaning / Disinfection Program:
a) Place both dialyzer quick connectors into the shunt and
close the door.
b) Place both concentrate connectors into their respective
rinse ports. This calls the "Select Program" screen (1).
c) Select the desired Cleaning / Disinfection Program
2
button. K machines, the button turns blue then press
the 'CONFIRM' key.
How to "Enter" Service Mode:
After power on, when the "Press CONFIRM for Service
Mode" message appears press the 'CONFIRM' key.
How to Enter Test and Calibration (T and C) Mode:
Swapping a sensor or function board may cause Conductivity
Errors on power up. T & C defeats these errors so the boards
can be tested without performing calibrations.
Enter Service Mode Options
(the 'x' turns blue). Turn the machine off, back on then enter whatever program is desired.
End of Operating Modes

OPERATING MODES

Hardware Options. Select "Yes" for T and C and press the 'CONFIRM' key
Fresenius 2008K Troubleshooting Guide
P/N 507298 Rev. B (Draft 1)
Page 12