F18
16
Connect to ZKBioAccess IVS Software
Set the Communication Address
Device Side
1.
Press M/OK on the initial interface. Select COMM. and press M/OK. Then, select Ethernet on the
Comm. Interface, press M/OK to set the IP address and gateway of the device.
(Note: The IP address should be able to communicate with the ZKBioAccess IVS server, preferably in the
same network segment with the server address.)
Select Cloud Server Setting on the Comm. Interface and press M/OK to set the server address and
2.
server port.
Server address: Set the IP address as of ZKBioAccess IVS server.
Server port: Set the server port as of ZKBioAccess IVS (The default is 8088).
Software Side
Login to ZKBioAccess IVS software, click System > Communication > Communication Monitor to set the
ADMS service port, as shown in the figure below:
Add Device on the Software
Add the device by searching. The process is as follows:
Click Access Control > Device > Search Device to open the Search interface in the software.
1.
Click Search, and it will prompt "Searching......".
2.
P a g e
| 61
Copyright©2023 ZKTECO CO., LTD. All rights reserved.
User Manual