Verifying The Installation Using The Self-Test Screen; Figure 2-11. Baystack 450 Switch Self-Test Screen - Nortel BayStack 450-24T Using Manual

Verifying the Installation Using the Self-Test Screen

If a monitor is connected to the switch (see "Console/Comm Port" on page 2-10),
you can observe the BayStack 450 switch Self-Test screen (Figure 2-11 shows an
example of a standalone switch Self-Test screen).
The results of the self-test are displayed briefly (5 or 10 seconds) on the Self-Test
screen, which is followed by the Nortel Networks Logo screen (Figure 2-12).
Note: The Self-Test screen remains displayed only if the self-test detects a
fatal error.
BayStack 450-xxx Self-Test
CPU RAM test
ASIC addressing test
ASIC buffer RAM test
ASIC buffer stack init test
Port internal loopback test
Cascade SRAM test
Fan test
Self-test complete.
Figure 2-11. BayStack 450 Switch Self-Test Screen
Note: The Self-Test screen for a switch that is participating in a stack
configuration includes an additional test:
309978-D Rev 01
... Pass
... Pass
... Pass
... Pass
... Pass
... Pass
... Pass
Cascade SRAM test.
Installing the BayStack 450 Switch
2-15