Figure 1-62. Port Mirroring Address-Based Screen Example - Nortel BayStack 450-24T Using Manual

Using the BayStack 450 10/100/1000 Series Switch
In this example, port 23 becomes the designated Monitor Port for switch S1 when
you press [Enter] in response to the [Yes] screen prompt.
Note: The screen data displayed at the bottom of the screen changes to show
the new currently active port mirroring configuration after you press [Enter].
The Monitoring Mode field [ Address A - > Address B ] indicates that all
traffic transmitted by address A to address B will be monitored by the StackProbe
attached to Monitor Port 23.
Note: When you enter MAC addresses in this screen, they are also displayed
in the MAC Address Table screen (see "MAC Address Table" on page 3-22).
Is your port mirroring configuration complete?
Currently Active Port Mirroring Configuration
---------------------------------------------
Monitoring Mode:
Port X: 25 Port Y: 24
Use space bar to display choices, press <Return> or <Enter> to select choice.
Press Ctrl-R to return to previous menu.
Figure 1-62. Port Mirroring Address-Based Screen Example
1-102
Port Mirroring Configuration
Monitoring Mode:
Monitor Unit/Port:
Unit/Port X:
Unit/Port Y:
Address A:
Address B:
-> Port X or
[ Address A
[ /23 ]
[ / ]
[ / ]
[ 00-44-55-44-55-22 ]
[ 00-33-44-33-22-44 ]
[ Yes ]
Port Y -> Monitor Port: 23
Press Ctrl-C to return to Main Menu.
-> Address B ]
309978-D Rev 01