Trunk Configuration Screen For Switch S2; Figure 1-52. Multilink Trunk Configuration Screen For Switch S - Nortel BayStack 450-24T Using Manual

Using the BayStack 450 10/100/1000 Series Switch

Trunk Configuration Screen for Switch S2

As shown in Figure 1-49 on page 1-80, switch S2 is set up with two trunk
configurations (T2 and T3). Both trunks connect directly to switch S1.
As in the previous screen examples, to set up a trunk configuration, choose
MultiLink Trunk Configuration from the MultiLink Trunk Configuration Menu.
Figure 1-52 shows the MultiLink Trunk Configuration screen for switch S2.
Trunk Trunk Members (Unit/Port)
----- ------------------------------- ------------ --------------- ------------
1 [ /25 ][
2 [ /1 ][
3 [ / ][
4 [ / ][
5 [ / ][
6 [ / ][
Trunk Trunk Name
----- ------------------
1 [ S2:T2 to S1 ]
2 [ S2:T3 to S1 ]
3 [ Trunk #3 ]
4 [ Trunk #4 ]
5 [ Trunk #5 ]
6 [ Trunk #6 ]
Enter text, press <Return> or <Enter> when complete.
Press Ctrl-R to return to previous menu.
Figure 1-52. MultiLink Trunk Configuration Screen for Switch S2
Switch S2 is configured as follows:
•
1-84
MultiLink Trunk Configuration
/26 ][ / ][ /
/3 ][ / ][ /
/ ][ / ][ /
/ ][ / ][ /
/ ][ / ][ /
/ ][ / ][ /
Trunk (read only) indicates the trunks (1 to 6) that correspond to the switch
ports specified in the Trunk Members fields.
STP Learning
] [ Normal ]
] [ Normal ]
] [ Normal ]
] [ Normal ]
] [ Normal ]
] [ Normal ]
Press Ctrl-C to return to Main Menu.
Trunk Mode Trunk Status
Basic [ Enabled
Basic [ Enabled
Basic [ Disabled ]
Basic [ Disabled ]
Basic [ Disabled ]
Basic [ Disabled ]
309978-D Rev 01
]
]