Nortel BayStack 450-24T Using Manual page 214

Using the BayStack 450 10/100/1000 Series Switch
Table 3-17. VLAN Port Configuration Screen Fields
Field
Filter Untagged Frames
Filter Unregistered Frames
Port Name
PVID
Port Priority
3-54
Description
Sets this port to filter (discard) all received untagged frames.
Restriction: If this port is a gigabit port or a BayStack 410-24T switch
port that is a protocol-based VLAN member, you cannot set this field
value to No. This restriction also applies if this port is a trunk member
with a gigabit port or a BayStack 410-24T switch port that is a
protocol-based VLAN member.
Default No
Range No, Yes
Sets this port to filter (discard) all received unregistered packets.
Default No
Range No, Yes
The default port name (with associated stack unit number when
configured) assigned to this port. You can change this field to any name
that is up to 16 characters long.
Default Unit x, Port x
Range Any ASCII string of up to 16 printable characters
Associates the port (specified in the Unit/Port fields) with a specific
VLAN. For example, if you associate a specific port with a PVID of 3, all
untagged frames received on the specified port are assigned to VLAN 3
(see also "AutoPVID (all ports)" field description, later in this table).
Default 1
Range 1 to 4094
Prioritizes the order in which the switch forwards packets received on
specified ports (see "IEEE 802.1p Prioritizing" on page 1-74).
Default 0
Range 0 to 7
(continued)
(continued)
309978-D Rev 01