Tooling - Installation (Qdc) - Danfoss ET5040 Operator's Manual

Danfoss ET5040 Crimp Machine Operator's Manual
Tooling Installation - Using Quick Die Change Tool QDC
Step 1
Figure 6
After fitting and hose selections are made on menu screens, screen will
display correct tooling for application.
Step 3
Figure 8
Position the QDC tool with crimp dies in the center of the crimp head.
Make sure the holding pins are aligned with the bore holes in the base or
intermediate dies and gradually jog - close the crimp head while confirming
all eight pins are aligned.
8 | ©Danfoss ET5040 Crimp Machine Operator's Manual | 2022.10.
Step 2
Figure 7
Align and insert the eight pins of the QDC tool with the holes in the front
of desired crimp dies in the storage rack. Rotate the handle to the right
(clockwise) to remove the crimp dies from the storage rack.
Step 4
Figure 8
Remove the QDC tool and retract the crimp head. Confirm the crimp dies
are secure, then press the check button to acknowledge installation of
correct tooling for application.
BC425481951279en-000101