Table of Contents
Advertisement
Danfoss ET5040 Crimp Machine Operator's Manual
Operating Instructions
Crimp Selections - Auto Mode Continued
Figure 22
Step 10
Load hose & fitting into machine.
1.
Locate fitting to proper position.
2.
Activate crimper by depressing cycle start button on controller or foot
pedal if activated.
Step 11
1.
After first crimp, compare achieved crimp dimensions
2.
against crimp specifications.
Step 12
If achieved crimp is larger or smaller than
specification, enter offset to correct. Offset
will automatically be saved for specific hose
configuration.
!
NOTE: Product assembly information is
displayed in box on right side of screen. Additional
information (Such as photos, See figure 22 & 23) are
available by pressing the question mark icon. (See
figure 21).
13 | ©Danfoss ET5040 Crimp Machine Operator's Manual | 2022.10.
Figure 23
Figure 24
BC425481951279en-000101
Advertisement
Table of Contents
