Danfoss ET5040 Operator's Manual page 16

Danfoss ET5040 Crimp Machine Operator's Manual
Operating Instructions
Manual Operation Continued
Icon Explanations:
Data entry field for naming custom
crimp specification. Note: Entry
not required for operation. Save
required to retain for future use.
Offset for achieved diameter correc-
tion. Click icon to enter value.
Quick die change: Initiates the die
change, install sequence. (Touch to
change).
Select number of pieces to crimp.
!
NOTE:TNot required to crimp.
"0" selection will allow unlimited
crimps.
16 | ©Danfoss ET5040 Crimp Machine Operator's Manual | 2022.10.
Clears data entered from data entry
field.
Set dwell time. (Time at fully closed
position prior to auto open)
Save data to user input database.
Displays total number of pieces
crimped so far.
Crimp diameter target (User defined
via pop up numerical keypad).
Tooling diameter. Tooling auto pop-
ulates, displaying suggested tooling
for target crimp diameter. Note:
User may input an alternate tooling
selection.
Additional inputs (to switch param-
eters) (Page 17)
Displays current position of crimp
tooling/pressure of crimp.
Set desired automatic retract open-
ing diameter/ position.
!
NOTE: The crimp tooling
automatically retracts to this open-
ing diameter only when green icon
is displayed.
Auto Open
Red - Off
Green - On
(Touch icon to change)
Return to "Home" screen.
BC425481951279en-000101