Danfoss ET5040 Crimp Machine Operator's Manual
Settings
Setting #4 - Tooling Editor
Figure 37
Add a new die set to the list.
Proceed to next setting (forward).
21 | ©Danfoss ET5040 Crimp Machine Operator's Manual | 2022.10.
Dies displayed by
nominal size. Example:
ET5040DC-M320S = 32.0
Delete a die set from the list.
Exit settings menu.
!
NOTE: When the machine is delivered, the tooling editor contains all
of the Danfoss die sets. Remove the dies not purchased with the machine
to direct the machine to the available dies. (See figure 37)
Restore complete Danfoss tooling
list.
Return to previous setting (back).
BC425481951279en-000101