Operating Instructions Crimp Selections - Auto Mode - Danfoss ET5040 Operator's Manual

Crimp machine

Table of Contents

Danfoss ET5040 Crimp Machine Operator's Manual

Operating Instructions Crimp Selections - Auto Mode

Follow the settings and calibration steps prior to initial production use of the machine (Page 19)

Step 1

Figure 14

Rotate the main power switch (See figure 14) on the right side of the

machine to the "On" position. Wait for the machine to boot up.

Step 3

Figure 16

Select desired product line. (See figure 16)

• Aeroquip

• Everflex

• Industrial

• Weatherhead

• Synflex

Note: Favorites icon provides direct selection of commonly

used crimp selections.

11 | ©Danfoss ET5040 Crimp Machine Operator's Manual | 2022.10.

Step 2

Figure 15

Select "Crimp Selections" for Danfoss Factory Pre-populated Specifications

(See figure 15)

Step 4

Figure 17

Select Hose Series (Use either method A or method B):

Use scroll bar on right side of screen to scroll through the available

hose series. Make selection by touching hose series, then press check

mark. (See figure 17)

Touch filter box on the left, key pad will pop up, type in desired hose

series and press check mark.

Note: Key pad will disappear and selected series will populate in option

A. Then press check mark.

BC425481951279en-000101

Table of Contents