Danfoss ET5040 Crimp Machine Operator's Manual
Operating Instructions
Manual Operation
Follow the settings and calibration steps prior to initial production use of the machine (Page 18)
!
NOTE: Manual Operation is for crimping hose & fittings not in the pre-populated Danfoss database.
Step 1
Figure 25
Rotate the main power switch located on the right side of the machine to
the "On" position. Wait for the machine to boot up. (See figure 25)
Step 3
Figure 27
Manual Operation Screen is shown in figure 27. See explanation of all icon
on page 16. See operation sequence on page 18.
15 | ©Danfoss ET5040 Crimp Machine Operator's Manual | 2022.10.
Step 2
Figure 26
Select "Manual Operation". (See figure 26) Note: "Manual Operation" allows
operator to enter and save their own desired crimp specifications.
BC425481951279en-000101