Safety Instructions - Danfoss ET5040 Operator's Manual

Danfoss ET5040 Crimp Machine Operator's Manual
Important Safety Information
! WARNING
Failure to follow Danfoss process and product instructions and limitations
could lead to premature hose assembly failures, resulting in property
damage, serious injury or death.
Danfoss fitting tolerances are engineered to match Danfoss hose tolerances.
The use of Danfoss fittings on hose supplied by other manufacturers and/
or the use of Danfoss hose with fittings supplied by other manufacturers

Safety Instructions

Read and understand the operator's manual before attempting to operate
this machine. Failure to follow operating instructions could result in injury or
damage to the equipment.
1. Prevent Unauthorized
Operation
Do not permit anyone to operate
this machine unless they have
read and thoroughly understand
this manual. Failure to follow
operating instructions could
result in injury or damage to the
equipment.
2. Wear Safety Glasses
Risk of eye injury! Eye protection
required at all times during
the installation, operation and
maintenance of this machine.
3. Avoid Pinch Points
tay clear of the crimp ring, keep
your hands clear of all moving
3 | ©Danfoss ET5040 Crimp Machine Operator's Manual | 2022.10.
parts. Do not allow anyone, other
than the operator, to stand close
to the machine.
4. Maintain Dies with Care
Dies used in the crimp machine
are hardened steel, offering the
best combination of strength
and wear resistance for long
life. Hardened dies are generally
brittle and care should be taken
to avoid any sharp impact. Never
strike a die with a hardened
instrument.
5. Use Only Specified Danfoss
Products
Use Only Danfoss or Danfoss
approved products.
may result in the production of unreliable and unsafe hose assemblies and
is neither recommended nor authorized by Danfoss. Read and understand
the operator's manual before attempting to operate any equipment.
Danfoss hereby disclaims any obligation or liability (including incidental and
consequential damages) arising from breach of contract, warranty, or tort
(under negligence or strict liability theories) should Danfoss hose, fittings or
assembly equipment be used with the hose, fittings or assembly equipment
supplied by another manufacturer, or in the event that product instructions
for each specified hose assembly are not followed.
6. Verify Correct Crimp
Diameters
Check and verify correct crimp
diameters of all fittings after
crimping. Do not put any hose
assemblies into service if the
crimp diameters do not meet
Danfoss crimp specifications.
7. Die Change
Follow prescribed directions
regarding tooling change in the
manual.
8. Keep Work Area Clean
Cluttered areas and benches
invite accidents.
9. Emergency Stop Button
The controller is provided with
an emergency stop button. In
case of an emergency, actuate
the emergency button on the
front of the controller. After the
emergency stop button has
been activated, the production
area is without function, but all
assemblies are still energized.
De-energize the equipment via
the main switch.
BC425481951279en-000101