Setting Up Gps - Agilent Technologies E7473A Getting Started Manual

Loading, Connecting, and Using the Backpack

Setting Up GPS

Setting Up GPS
The backpack has been designed to accommodate a GPS receiver and
antenna, as an alternative configuration. The GPS antenna fits snugly in the
pocket in the top flap of the backpack, and the antenna cable fits through the
opening in the top of the backpack.
NOTE
The E74xx software works with either a GPS receiver or a computer pen, not
both at the same time. It is recommended that you configure separate projects
for each use. Refer to the online help for details.
To Set Up the Backpack for Use with GPS
1. Position equipment as you see in
2. Fasten the GPS receiver into the second receiver position, using the
3. Place the GPS antenna in the pocket in the top flap of the backpack, as
4. Thread the GPS antenna cable down through the hole in the top of the
5. Connect the RS-232 cable to the GPS receiver, then connect the other end
Agilent Wireless Solutions
Agilent receiver.
system of straps.
shown in Figure 1-20 on page
backpack and connect it to the GPS receiver.
to the Agilent receiver.
Figure 1-1 on page 14, with a single
50.
49