Hands-Free Pen Tablet And Phone Pouch - Agilent Technologies E7473A Getting Started Manual

Hands-free Pen Tablet and Phone Pouch

Loading, Connecting, and Using the Backpack
Suiting Up to Take Measurements
You can use the pen tablet without the backpack by connecting it to the
harness. The phone pouch attaches directly to your belt, or you can attach the
phones to your belt directly.
To Attach the Pen Tablet to the Hands-free Platform
Refer to Figure 1-15 on page
1. Lay the pen tablet in its case face down on a table or counter.
2. Press the hands-free platform onto the pen tablet case placing it so that the
velcro tabs align.
3. Fasten the tabs down.
4. Turn the pen tablet over and check that the strap lengths are
approximately the same.
To Put on the Harness and Attach It to the Pen Tablet
1. Put the harness straps over your shoulders, positioned so that the Agilent
label on the webbing falls approximately between your shoulder blades.
2. Sit in a chair, place the pen tablet in your lap, and connect the back of it to
the harness at the waist.
3. Tighten the waist straps by pulling the strap toward the rear (refer to
Figure 1-12 on page
correctly on your torso.
4. Attach the platform connectors to the D-rings on the harness, selecting the
set that best accommodates your height. Make sure the connectors snap
completely into place. See
5. Stand and adjust the length of the pen tablet platform straps to the proper
length. (Refer to
and loosening straps)
44
41.
38). This helps to keep the harness positioned
Figure 1-16 on page
Figure 1-12 on page 38
42.
for information on tightening
Agilent Wireless Solutions