Agilent Technologies
E5850A Time Correlation Fixture
Quick Start/Installation Guide
The Agilent E5850A time correlation
fixture allows you to make time-correlated
measurements between a 1680/90 or 16700 logic
analyzer and an Agilent 548XX series Infiniium
oscilloscope. The instruments communicate
with one another through a LAN connection
and through the time correlation fixture. The
instruments connect to your target system
(device undertest) through separate probes,
just as when they are used independently.
Waveforms acquired by the oscilloscope can
be displayed on the logic analyzer.
Equipment Supplied
Point-to-point cable
5061-7342
BNC cables (4)
8120-1840
You may use your own BNC
cables or combine two short
cables into a longer one using
the provided connector.
Equipment Required
Agilent 16700-series logic
analysis system, software
version 2.50 or later.
Note: The E5850A Time Correlation Fixture requires a 548xx Infiniium oscilloscope and either a 16700-series logic analysis
system or a 1680/90-series logic analysis system.
E5850A time
correlation fixture
CD-ROMs:
16700 software
Infiniium software update
Documentation
Agilent 548xx Infiniium
oscilloscope, with a probe.
548xxA models require
software version 4.00 or later.
Power supply and power cord
WARNING Shock hazard. Use
!
only the 0950-2546 power supply
Caution Equipment damage. Use
only the 0950-2546 power supply
and cord.
If the cord you received is not
appropriate for your electrical
power outlet type, contact your
Agilent Technologies sales and
service office.
Agilent 1680/90-series logic
analysis system, software
version 1.40 or later.