Agilent Technologies E7473A Getting Started Manual page 81

Solving Problems and Updating Your System
Troubleshooting Resource Problems and COM Errors
Table 5-1
Do This
1 Check the project and configuration being
2 Check system hardware components.
NOTE
COM Errors may occur if the SAGEM phone is not set in the correct
operating mode. The correct mode is TRACE.
When the SAGEM phone is in DATA mode, the interface connection is used
for transmitting fax and other data transmission types. When the SAGEM
phone is in TRACE mode, the interface connection is used for transmitting
measurement reports.
To change the mode, switch on the phone and use the following phone
keystrokes:
•
•
Agilent Wireless Solutions
used by the application.
, , Down Arrow,
[Menu] [44]
Use the up and down arrows to select TRACE mode, then select OK.
Additional Information
• Does the hardware configuration for the
project selected match the actual system
hardware?
• Is the correct Agilent receiver model number
and COM port selection shown in
Configuration under the Hardware tab?
• Is the correct phone model number and COM
port selection shown in the Configuration
under the Hardware tab?
• Is DC power provided to the Agilent digital
receiver?
,
[#] [8]
85