Chapter 6 Function Parameter List - Veichi JT550 Series Manual

Chapter 7 Maintenance and Troubleshooting
The symbols in the function code table are described as follow:
"●" : represents the parameter can be modified while the inverter is operating;
"〇" : represents the parameter cannot be modified while the inverter is operating;
"◇" : represents the parameter is the measured value and cannot be modified;
"X" : represents "Factory Parameter", which is subject to the manufacturer only.
Function
Parameter Name
Codes
F0.00 G/P Type Display
F0.01 Motor Control Mode
Operation Command
F0.02
Source Selection
Main Frequency(X)
F0.03
Source Selection
Auxiliary Frequency(Y)
F0.04
Source Selection
Selection Range of
F0.05 Auxiliary Frequency Y
for X and Y
Range of Auxiliary
F0.06
Frequency Y for X and Y

Chapter 6 Function Parameter List

1: G Type (Constant Torque Load)
2: P Type (Variable Torque Load e.g. Fan
and Pump)
0: Sensor-less Flux Vector Control(SVC)
1: Closed-Loop Vector Control(FVC)
2: Voltage/Frequency (V/F)Control
0: Keyboard Control
1: Terminal Control
2: Communication Control
0:Digital Setting
(don't save at power failure)
1: Digital Setting (save at power failure)
2: AI1
3: AI2
4: AI3
5: Pulse Setting (X5)
6: Multiple Commands
7: Simple PLC
8: PID
9: Communication Setting
10:AI1+AI2
11:AI1-AI2
12:max(AI1,AI2)
13:min(AI1,AI2)
Same as F0.03
0:Relative to the Maximum Frequency
1:Relative to the Main Speed
0%~150%
Range of Settings
- 46 -
JT550 Series Inverter Manual
Default
Property
Model
Dependent
〇
2
〇
0 ●
4
〇
0
〇
0 ●
100% ●