Initialization Of Parameters; Operation Commands Source Selection - Veichi JT550 Series Manual

Chapter 5 Basic Operation and Test Run
Figure 5.3 Inverter's Adjustment Sub-Process Flow (Vector Control)

5.5 Initialization of Parameters

Restore all of settings to default values. After the initialization, F0.24 is automatically set to 0.
F0.24
1: Restore default settings except motor parameters
If F0.24 is set to 1, most function codes are restored to the default settings except motor
frequency reference resolution, errors records, accumulated operating time,
and accumulated power consumption .
2: Clear records
If F0.24 is set to 2, the fault records, accumulated running time , accumulated power-on time and
accumulated power consumption are cleared.

5.6 Operation Commands Source Selection

F0.02
0: Operation panel control
Commands are given by pressing keys "RUN,STOP"on the operation panel.
1: Terminal control
Commands are given by means of multifunctional input terminals with functions such as "FWD,
JOGF, and JOGR".
2: Communication control
Commands are given from the host computer.
Restore Default Settings
Command Source Options
Range：0~501
Range：0~2
- 42 -
JT550 Series inverter Manual
Default：0
parameters,
accumulated power-on time
Default：0
REV,