Veichi JT550 Series Manual page 86

Chapter 7 Maintenance and Troubleshooting
Two typical setting examples are shown in the following Figure .
F2.20 AI curve 2 minimum input
Corresponding setting of AI
F2.21
curve 2 minimum input
F2.22 AI curve 2maximum input
Corresponding setting of AI
F2.23
curve 2maximum input
F2.24 AI curve 3 minimum input
Corresponding setting of AI
F2.25
curve 3 minimum input
F2.26 AI curve 3 maximum input
Corresponding setting of AI
F2.27
curve 3 maximum input
Please refer to the AI1 when use AI2 and AI3 curve function.
F2.28 PULSE minimum input
Corresponding setting of
F2.29
PULSE minimum input
F2.30 PULSE maximum input
Corresponding setting of
F2.31
PULSE maximum input
This group function code is used to set the relationship between the pulse frequency and the corresponding
set X5 between. Pulse frequency inverter can only enter through X5 channel.
F2.32 PULSE filter time
PULSE input filtering time is defined on the input signal filtering. Long filtering time the strong
anti-interference ability, but the corresponding slowdowns; filtering the fast response time is short, but
immunity is weakened.
Range:0.00V~F2.22
Range:-100.0%~+100.0%
Range:F2.20~+10.00V
Range:-100.0%~+100.0%
Range:0.00V~F2.26
Range:-100.0%~+100.0%
Range:F2.24~+10.00V
Range:-100.0%~+100.0%
Range:0.00kHz~F2.30
Range:-100.0%~100.0%
Range:F2.28~100.00kHz
Range:-100.0%~100.0%
Range:0.00s~10.00s
- 86 -
JT550 Series Inverter Manual
Default:0.20V
Default:0.0%
Default:10.00V
Default:100.0%
Default:0.20V
Default:0.0%
Default:10.00V
Default:100.0%
Default:0.00kHz
Default:0.0%
Default:50.00kHz
Default:100.0%
Default:0.10s