Table of Contents
Advertisement
Camera Adjustment, Light Profile
For all cameras:
1. Select RGB (circled with red in image below).
2. Loosen/remove the Stepper Motor Fixing Screw (7).
3. Turn the Vertical Position Adjustment Wheel (8) until the cameras show undisturbed light
profiles as shown below.
4. Select Camera Adj. (circled with green in image below), this will adjust gain and offset. Wait
until the light profiles have "settled".
5. If no light profile visible, validate that camera is working by shining light into the camera lense.
For all cameras: Adjust vertical position until profile is visible.
HD Ultra X Service Guide
Page 105
Advertisement
Table of Contents
