Table of Contents
Advertisement
12. Lift the OTAC and refit the brass spacers at both ends.
13. While pressing down on the Guide Plate, to align the screw holes, and using paper to cover
the gap to prevent the screw falling into the chassis, refit the long T20 screw. Do this at both
ends of the Guide Plate.
14. Use pliers, or e-clip tool, to refit the e-clips over the Gas Piston bracket. Make sure it is fully
clicked in place. Repeat at both ends.
15. Refit the OTAC Top Cover.
16. Check the Lid Sensor, adjust if necessary. Go to page 101 for instructions.
HD Ultra X Service Guide
Page 37
Advertisement
Table of Contents
