Replacing Parts; Otac Assembly (Guide Plate Assembly) - Contex HD Ultra X 6000 Technical Service Manual

6. Replacing Parts

OTAC Assembly (Guide Plate Assembly)

Tools:
Prerequisites:
1. Raise the OTAC to its highest position by depressing the release button, and then open the
OTAC.
2. Use a cloth (or similar) to cover the gap in the lower chassis, to prevent the e-clip from falling
into the chassis, then remove the E-clip using pliers/e-clip removal tool.

T20 Torx Screwdriver

Pliers

Remove the OTAC Top Cover (see page 30).

Remove the Feed Table Cover (see page 24).

Remove LH & RH Side Cover (see pages 17& 21).
HD Ultra X Service Guide
Page 33