Controller Board (Sux Variant A) - Contex HD Ultra X 6000 Technical Service Manual

Controller Board (SUX Variant A)

Tools:
Prerequisites:
1. Press down on both the locating tabs at either end of the connectors and pull the flat-cable
free from the connector.
2. Remove all the Flat-cables in the same way.
3. Remove all the remaining accessible cables.
4. Remove the 4 x T10 screws holding the Controller Board to the chassis. The 2 end screws
can be accessed via holes in the top plate bracket.

T10 screwdriver.

Remove the Feed Table Cover (see page 24).

Remove RH Side Cover (see page 17).
HD Ultra X Service Guide
Page 51