Inspect The Service/Parking Brake - Taylor-Dunn C0-014-32 Operation, T Roubleshooting And Replacement Parts Manual

Maintenance, Service, and Repair

INSPECT THE SERVICE/PARKING BRAKE

Current Taylor-Dunn
the possibility that the original brakes were replaced with aftermarket
parts containing asbestos. Since this possibility exists, all brake parts
should be handled as if they contain asbestos. Refer to Appendix C
for recommended handling precautions.
The band brake is located on the front of the drive chain
case housing, it must be removed to accurately measure
the lining thickness. Refer to
Lining
for information on removing the band brake.
1. Measure the thickness of the brake lining at its
thinnest point. If it is 1/16-inch or less, then the
brake band must be replaced.
2. Measure the run out of the brake drum. If it is
more than 0.010-inches then it must be machined
or replaced. Do not machine the brake drum
beyond its service limits.
3. Measure the diameter of the brake drum. If it is
less than 5.85-inches then the brake drum must
be replaced.
4. Inspect all brake cables and linkages for any signs
of damage or wear.
6. Reconnect the main positive and negative cables
at the batteries.
7. Remove blocks from behind the wheels.
8. Test drive the vehicle.
Brakes
Page 2
brakes are asbestos free. However, there is
®
Replace the Brake