Reassemble; Motor Connector - Taylor-Dunn ET-3000 Manual

T-48 AC / ET 3000

Reassemble

1. Insert the armature/housing assembly into the
field housing` while carefully pulling the field cable
assemblies through the opening.
2. Install the sensor bearing and thermal sensor
grommets into their respective slots on the end
housing and bolt the end housing to the field housing.
3. Connect the two 'V' phase wire to the terminal stud.
4. Install the terminal cover and terminal nuts. Make
sure the cover is aligned with the marks made during
disassembly
5. Install the friction plate assembly with extended hub
facing out.
6. Place the electric brake spacers onto the motor
assembly.
7. Install the electric brake assembly. Make sure
the brake is aligned with the marks made during
disassembly.
8. Install the rubber seal ring around the brake. Make
sure it is seated correctly (Fig 4).
9. Remove the two 10-32 machine screws holding the
brake assembly together.
10. Install the fan, fan circlip, and fan housing.
11. Install the locking bolts for the four motor assembly
bolts (Fig 3).
MB-T48-02

MOTOR CONNECTOR

Spec 191624805 and 806
Spec 191649703
Motor Connector, Pin Side
Motor Connector, Wire Side
Motor
Page 5