Taylor-Dunn ET-3000 Manual page 113

T-48 AC / ET 3000
17. Install the locking roll pins into the housing and cover to lock the ring nuts in place.
18. Remove the pinion gear holding tool.
19. Install the primary reduction gear case, axles and housings, motor, and install the complete
drive onto the vehicle.
20. Fill the drive with oil. Refer to the
Refer to
Change Oil
21. Lower the vehicle.
22. Reconnect the main positive and negative cables at the batteries.
23. Remove the blocks from behind the wheels.
24. Test drive the vehicle.
MB-T48-02
Lube Chart
section for information regarding the proper oil level..
section for information regarding type of oil.
Transmission
Page 3