Taylor-Dunn ET-3000 Manual page 107

T-48 AC / ET 3000
19. Assemble the gear case in reverse order.
Note: Torque the drain plug to the specified amount listed in the Hardware
Note: Torque the gear case to 3rd member retaining bolts to the specified
Note: Torque the pinion nut to the specified amount listed in the Hardware
Note: Apply gasket sealer (#94-430-05) to the front flange on the 3rd
Note: Pack the motor seal with non-acetic based grease.
20. Fill the differential with oil.
Note: Refer to
21. Lower the vehicle.
22. Reconnect the main positive and negative cables at the batteries.
23. Remove the blocks from behind the wheels.
24. Test drive the vehicle.
MB-T48-02
Lubricate all parts with gear oil before installation. Failure to pre-lube
the parts may result in premature failure.
Torque Table at the end of this section.
amount listed in the Hardware Torque Table at the end of this
section.
Torque Table at the end of this section.
member and gear case cover.
Changing the Differential Oil
the drive with oil.
Transmission
for information on filling
Page 3