Remote Interface Configurations; Usb - Keysight N1911A Installation Manual

Remote Interface Configurations

The power meter can be remotely controlled by LAN, USB, and GPIB (IEEE488)
programming interfaces. This section shows you how to set the interface
configurations.
Only one interface should be used at any one time.
To connect the power meter to your PC, configure and verify your connection,
NOTE
you can use the Keysight IO Libraries Suite, the E2094M Keysight IO Libraries for
Windows, or an equivalent.
– Keysight IO Libraries Suite for Windows 98/2000/ME/XP. For information and
– E2094M Keysight IO Libraries for Windows 98/NT/2000/ME/XP. You can find
– You can also access other information about Keysight IO Libraries at
For more information on configurating the remote interface connectivity, refer to
NOTE
the Keysight Technologies USB/LAN/GPIB Interfaces Connectivity Guide. If you
have installed the IO Libraries Suite, you can access the connectivity guide via
the Keysight IO Libraries Control icon. Alternatively, you can access the
connectivity guide via the Web at www.keysight.com/find/connectivity.

USB

The USB interface requires no front panel configuration.
USB operation and configuration is supported by the version of VISA and SICL IO
libraries on your PC.
Keysight N1911A and N1912A Installation Guide
to install, use the Automation-Ready CD with Keysight IO Libraries Suite which
is shipped with the power meter.
information and install this application via the Web at
www.keysight.com/find/iolib.
www.keysight.com/find/iolib.
Getting Started
23
1