Getting Started
Remote Interface Configurations
The power meter is equipped with GPIB (IEEE488), RS232, and RS422 remote
programming interfaces. This section shows you how to change the interface
settings.
GPIB
The power meter is shipped from the factory with GPIB as the selected interface
and the address set to 13. Addresses between 0 and 30 are valid. The GPIB
address is stored in non-volatile memory. To change the address proceed as
follows:
28
System
1. Press
,
Remote Interface
. The GPIB address pop-up appears.
GPIB Addr
2. Use the
and
keys to select (highlight) the digit you want to change;
use the
and
keys to increase or decrease the value. Press
confirm and save the new address. Pressing
value.
To ensure the GPIB interface is selected press
,
Select Interface
GPIB
Remote Interface Configurations
,
Configure Interface
Selected digit
Cancel
.
,
,
GPIB
Enter
restores the previous
System
,
Remote Interface
EPM-P Installation Guide
to
,