Inserting The Power Module - Primedic HeartSave AED Operating Instructions Manual

Preparatory measures before (initial) start-up

5.3.1 Inserting the power module

Fig. 11: Inserting the power module
1 Release button
2 Power module tongue
3 Power module
The HeartSave is always supplied with a power module. All three different types of
power module are inserted the same way.
Procedure:
Lay the device on its back.
Push the power module (3) into the device in the direction shown by the arrow
(A) until it reaches the back as shown in the diagram.
Then press the front of the power module into the slot in the direction shown by
the arrow (B) until you hear a "click" as the release button (1) engages securely
with the tongue on the power module (2).
The power module should now be flush with the front housing of the device.
If the power module has been inserted correctly, then the device will start
automatically and will carry out a self-test. If applicable, follow the acoustic/visual
instructions from the device and then switch it off. The HeartSave AED is now ready
for use.
HeartSave AED / AED-M, 21212 / GB / E02
21