Page 2
Publisher METRAX GmbH Rheinwaldstr. 22 D-78628 Rottweil Germany Telephone: +49 (0) 741/257-0 Email: info.primedic@spacelabs.com Web: www.primedic.com Revision: Date of issue: 09/2015 Proprietary note METRAX GmbH reserves all rights to these operating instructions. These operating instructions may not be duplicated or made accessible to third parties without the approval of METRAX GmbH.
3.4 Inserting / replacing the SD card 3.5 Entering the Device Code for Remote Control 4 Using the device 4.1 Enable / Disable the PRIMEDIC™ HeartSave AED Trainer 4.1.1 Turn on the PRIMEDIC™ HeartSave AED Trainer 4.1.2 Turn off the PRIMEDIC™ HeartSave AED Trainer 4.2 Resuscitation Sequence...
You are preparing to face the task of learning to perform a competent training demonstration of the safe use of PRIMEDIC™ HeartSave AED Trainer . The HeartSave AED Trainer you have acquired is not a defibrillator, but is to be used solely for educational purposes and must not be used on patients.
Autonomous intervention, repairs or constructional changes to the device. • Autonomous overrunning of the performance limits. • Lack of monitoring parts that are subject to wear and tear. • Treating patients without prior indication. • METRAX GmbH 23560 HeartSave AED Trainer / GB / B02 5 / 24...
Strap to pull the cover off the device (with expiry date of SavePads) Carry handle Cover of the device Fig. 2: Rear View (Similar to) Specification plate Fixing for wall mounting 6 / 24 23560 HeartSave AED Trainer / GB / B02 METRAX GmbH...
Page 7
On/Off switch "Do not touch patient" symbol (lights up during ECG analysis) Loudspeaker Shock button (release button for defibrillation) Language change button (When a training device without function) METRAX GmbH 23560 HeartSave AED Trainer / GB / B02 7 / 24...
Description of device Note Additionally added to the PRIMEDIC ™ Heart AED are nitrile gloves, a razor, a ventilation cloth and a pair of scissors. 2.2.3 Accessories PRIMEDIC™ Trainer Energy Module DD / AS; Order No.: 96696 • PRIMEDIC™ TrainerCable AS/DD for trainer electrodes; Order No.: 97185 •...
The PRIMEDIC ™ Heart Save AED Trainer can be used with commercially available alkaline batteries or AA batteries. Before the first use of the PRIMEDIC ™ Heart Save AED Trainer you must first insert the batteries / rechargeable batteries in the battery compartment.
To remove or change to the SD card, you must first remove the power module. Procedure: Insert the SD card into the card slot. Note Make sure that the contacts on the SD card show upwards! METRAX GmbH 23560 HeartSave AED Trainer / GB / B02 13 / 24...
Enter "1 6 0". Following this the red LED goes out and the remote control is ready for operation. Battery Fig. 14: Remote Control – Installing the Batteries 14 / 24 23560 HeartSave AED Trainer / GB / B02 METRAX GmbH...
Using the device 4 Using the device To operate the PRIMEDIC ™ HeartSave AED trainer the remote control is required. 4.1 Enable / Disable the PRIMEDIC™ HeartSave AED Trainer 4.1.1 Turn on the PRIMEDIC™ HeartSave AED Trainer The device is automatically activated by removing its cover. If no device cover is used or if the unit does not turn on automatically, turn it on by pressing the On / Off button.
Page 16
Analyse, No shock required 2 Defibrillations needed 2 min CPR Not requiring defibrillation Analyse, Shock required rhythm 2 min CPR 2 Defibrillations needed Analyse, Shock required Not requiring defibrillation 16 / 24 23560 HeartSave AED Trainer / GB / B02 METRAX GmbH...
Note During the analysis is not possible to change the mode Note The setting is saved until the energy module is removed. METRAX GmbH 23560 HeartSave AED Trainer / GB / B02 17 / 24...
4.2.4 Automatic start of analysis You can set the HeartSave AED Trainer in such a way that the analysis starts automatically. In this case the patient impedance must not be added using the remote control. Proceed as follows to activate this function: ...
< Check electrodes > < Apply electrodes one after the other to patient's bare chest > If the plug on the PRIMEDIC™ SavePads Trainer has not been inserted in the unit, the following additional instruction appears < Plug in electrode cable >...
Do not immerse the device in liquids Use damp cloths to clean Clean HeartSave AED Trainer and all its accessories with commercially available household cleaners. Use a slightly damp, clean cloth. Use ordinary surface disinfectants to disinfect (e.g. Gigasept FF, Bacillol or Spitacid).
Technical Data 8 Technical Data Power supply Battery 6 x AA alkaline batteries (for the PRIMEDIC ™ HeartSave AED Trainer) 2 x AAA alkaline batteries (for remote control) alternatively, commercially available batteries Operating time min. 20 h with standard alkaline batteries...
METRAX GmbH. METRAX After-Sales Service is glad to be at your disposal, even after the warranty period has expired. METRAX GmbH 23560 HeartSave AED Trainer / GB / B02 23 / 24...