Inserting / Replacing The Energy Module; Inserting The Power Module - Primedic HeartSave Operating Instructions Manual

Preparatory measures before (initial) start-up
Fig. 10: Power Module Open
 The six batteries / rechargeable batteries are inserted into the lower tray. Pay attention
to the correct polarity!

3.3 Inserting / replacing the energy module

3.3.1 Inserting the power module

Fig. 11: Removing the power module
Procedure:
 Lay the device on its back.
 Push the (new) battery (1) in the direction of the arrow (3) into the device until it
reaches its end position as shown in the diagram.
 Then press the battery in the direction of the arrow (4) into the power module slot
until the release button (2) locks the power module tongue securely into position.
 Press the battery completely into the device until you hear the "click" when it slots
into place and the battery
is flush with the outside edge of the device.
 After this, the device will carry out a self-test and is ready to use.
12 / 24 23560 HeartSave AED Trainer / GB / B02 METRAX GmbH