Table of Contents
Advertisement
Preparatory measures before (initial) start-up
5.8 Simple change of configuration – example: Time
To change the time, proceed as follows:
Navigate the cursor by pressing the key down several times to the menu item
< To page 2 >
Press this several times to get to page 3.
Move the cursor by pressing the key to the menu item Time. Select the
highlighted menu item Time by pressing the
Change the hour by pressing the or key.
Confirm the correct value with the
change this as described under 3 and then press the key
To exit the setup menu, move the marking with the key to the menu item End
Setup and confirm this with the key
If no key is pressed for one minute, the device automatically leaves the setup
Note
menu and goes back to standby.
5.9 Changing the PIN
The PIN is used to save profiles. Entering a PIN is absolutely necessary. If you want to
change the PIN you will always need to know the old PIN. proceed as follows:
Use the key
Change to page 4 of the menu
Navigate with the key to the entry < PIN > and confirm your selection with the
key
Enter the current PIN as follows: Using the keys you can increase or
decrease a digit. With the key
fourth digit, it jumps back to the menu item
Navigate to the entry < New PIN > and enter your new PIN as described above.
Navigate to the entry < Repeat PIN > and enter your PIN again.
Select the menu parameter < Change PIN > and confirm your new PIN with the
key
.
On the right next to the cursor the entry < OK > should appear. This means your
new PIN is active.
When the device is first delivered, the PIN is always set in the factory to
Note
0000.
HeartSave AED / AED-M, 21212 / GB / E02
key. The minute is now highlighted. Then
.
to change into the setup menu
you can change to the next digit. After the
key. The hour is then highlighted.
29
Advertisement
Table of Contents
