Inserting / Changing The Power Supply Unit (Battery); Inserting The Battery - Primedic HeartSave PAD Operating Instructions Manual

Preparatory measures before (initial) start-up

5.3 Inserting / Changing the power supply unit (Battery)

Before using the PRIMEDIC™ HeartSave PAD for the first time, the battery has to be
inserted in the appropriate slot.
Note

5.3.1 Inserting the battery

Fig. 8: Inserting the battery
Procedure:
Note
Operating instructions
24
The HeartSave PAD is always supplied with a battery.
Check the status display every time after you have used the device. If
necessary, the battery should be exchanged for a new one.
Lay the device on its back.
Push the (new) battery (3) in the direction of the arrow (1st) into the device until
it reaches its end position as shown in the diagram.
Then press the battery at the front in the direction of the arrow (2nd) into the
power module slot until the release button (4) locks the power module tongue
securely into position.
Press the power module completely into the device until you hear the "click"
when it slots into place and the power module is flush with the outside edge of
the device.
If the battery has been installed correctly, the device will start independently
once the cover of the housing has been removed and it will run a self-test.
Now follow the acoustic instructions from the device and then switch it off.
Now the device is ready to use.
HeartSave PAD 22289 / GB / C