Table of Contents
Advertisement
Preparatory measures before (initial) start-up
5.2.1 Inserting the PRIMEDIC
Before switching the device on for the first time, insert the SaveCard into the specially
designed slot (2). Gently press the SaveCard in until the button (1) projects slightly out
of the device. Now insert the power module into the device.
Note
5.2.2 Changing the PRIMEDIC
Before you can remove or replace the SaveCard, you must first remove the power
module.
Procedure:
5.3 Inserting / replacing the energy module
The PRIMEDIC™ HeartSave AED can be operated using 3 different power modules:
Before using the PRIMEDIC™ HeartSave for the first time, the
power module has to be inserted in the appropriate slot.
Operating Instructions
20
TM
The device will now start automatically and will perform a self-test. The data
saved on the SaveCard should be archived externally after every deployment
if possible. Once the storage capacity of the SaveCard is exhausted, no
further data will be saved. The device remains ready for operation even if the
memory is exhausted and even without a SaveCard.
TM
Press the button (1) in fully - this pushes the SaveCard (2) slightly out of its
holder.
Remove the SaveCard and insert a new one into the equipment with the plug end
going in first.
Gently press the card in until the button (1) projects slightly out of the device.
Finally insert the power module into the device again.
The HeartSave AED will be ready for operation again after it carries out a
subsequent self-test
A disposable LiMnO
battery,
2
A rechargeable AkuPak (optional)
PowerLine (optional)
Whenever the device has been used, check the power level.
If necessary, replace the battery or recharge the battery pack.
If this is not possible make sure you always have a second,
fully charged battery to hand to ensure that the device is
always ready for use!
HeartSave AED / AED-M, 21212 / GB / E02
SaveCard
SaveCard
CAUTION
Advertisement
Table of Contents
