Removing The Power Module From The Device - Primedic HeartSave AED Operating Instructions Manual

Preparatory measures before (initial) start-up

5.3.2 Removing the power module from the device

Fig. 12: Removing the power module
Operating Instructions
22
Monitor the Status Display. If the display is showing "OK",
the device is ready to use. (If applicable), switch it off using
the on / off button or put the device cover back on. If the
display does not read "OK" or if a fault message appears on
the monitor, remedy the cause or contact your nearest
service station.
1 Release button
2 Power module tongue
3 Power module
Only change the power module when the device is switched
off and electrode plug is disconnected.
HeartSave AED / AED-M, 21212 / GB / E02
CAUTION
CAUTION