Inserting / Changing The Savecard - Primedic HeartSave PAD Operating Instructions Manual

Preparatory measures before (initial) start-up

5.2 Inserting / Changing the SaveCard

Fig. 7: Inserting / Changing the SaveCard
To remove the SaveCard or to change it, you first of all have to remove the power
module.
Procedure:
Press the button (1) in fully – this pushes the SaveCard (2) slightly out of its
holder.
Completely remove the SaveCard from the device and transfer the data (if
applicable) onto a PC and insert this card or a new one into the device with the
pin end first.
Gently press the card in until the button (1) projects slightly out of the device.
Finally insert the power module into the device again.
After this, the device will carry out a self-test and is ready to use.
The data saved on the SaveCard should be filed externally after every
Note
deployment if possible. If the memory capacity of the SaveCard is full, then
no further data will be saved. The device is ready for use both with an
exhausted memory and also without a SaveCard.
To read out the saved data, you can use the software PRIMEDIC™ ECG
Viewer which is available as an optional accessory.
Operating instructions HeartSave PAD 22289 / GB / C
23