Further Actions In Step 7/Ncm Pc - Siemens SIMATIC HMI IPC577C Operating Instructions Manual

Detailed descriptions
17.5 CP 1616 onboard communications processor
CAUTION
Be aware that aborting the loading process may result in an inconsistent state in your
module.
You can find additional, detailed information about the individual loader variants in the
integrated help.
NOTICE
When loading the firmware or commissioning the module, be aware that the CP 1616
onboard takes five MAC addresses (always in direct sequence). The first two are shown in
the BIOS.
Figure 17-18 Advanced menu Peripheral Configuration
Example
The lower MAC address at "Profinet" is provided for Layer 2 communication, while the
second one is used for Ethernet/PROFINET communication.
17.5.4

Further actions in STEP 7/NCM PC

Configuring
Your PC is now ready, although you still have to configure the SIMATIC NET communication
software. The rest of the procedure is described in the "Commissioning PC Stations" manual
(on the Windows PC that also contains STEP 7/NCM PC: Start > Simatic > Documentation >
English > Commissioning PC Stations).
180
SIMATIC HMI IPC577C
Operating Instructions, 10/2010, A5E02368074-02