Alarm, Error And System Messages; Boot Error Messages - Siemens SIMATIC HMI IPC577C Operating Instructions Manual

Alarm, error and system messages

13.1

Boot error messages

During startup (the boot process), the BIOS first performs a Power On Self Test (POST) and
checks whether certain functional units of the PC are operating error-free. The boot
sequence is immediately interrupted if critical errors occur.
If the POST does not return an error, the BIOS initializes and tests further functional units. In
this startup phase, the graphics controller is initialized and any error messages are output to
the screen.
The following lists the error messages from the system BIOS. For information on error
messages output by the operating system or programs, refer to the corresponding manuals.
On-screen error messages
On-screen error message
Address conflict
Combination not supported
IO device IRQ conflict
Invalid system configuration data Plug-and-Play problem
Allocation Error for ...
System battery is dead.
Replace and run SETUP
System CMOS checksum bad
Run SETUP
Failure Fixed Disk
System RAM Failed at offset:
Shadow RAM Failed at offset:
Extended RAM Failed at offset:
Failing Bits:
SIMATIC HMI IPC577C
Operating Instructions, 10/2010, A5E02368074-02
Meaning / suggestions
Plug-and-Play problem.
Contact your technical support team.
Plug-and-Play problem.
Contact your technical support team.
Plug-and-Play problem.
Contact your technical support team.
Set the RESET CONFIGURATION DATA option in the

"Advanced" menu of Setup.
Contact your technical support team.

Plug-and-Play problem
Please undo the last hardware change.

Contact your technical support team.

The battery on the CPU module is defective or dead.
Contact your technical support team.
Call up SETUP, adjust settings and save. If this message appears
during each startup, contact your technical support team.
Error accessing the hard drive.
Check the SETUP settings.
Contact your technical support team.
Memory error.
Contact your technical support team.
Memory error.
Contact your technical support team.
Memory error.
Contact your technical support team.
Memory error.
Contact your technical support team.
13
121