Partitioning Data Media; Setting Up The Partitions Under Windows Embedded Standard 2009 - Siemens SIMATIC HMI IPC577C Operating Instructions Manual

Maintenance and Service

12.4 Partitioning data media

12.4 Partitioning data media
12.4.1

Setting up the partitions under Windows Embedded Standard 2009

You need to set up the partitions on the CompactFlash card after installing a new drive, to
repair corrupt partitions or to change the partitioning.
Partitioning the CompactFlash card
In delivery state, the following default partitions are set up on the CompactFlash card for
Windows Embedded Standard 2009:
Partition
1. Partition
2. Partition
* Due to partitioning/formatting, the actual CompactFlash capacity does not correspond to
the memory size specified on the CompactFlash.
Partitioning the hard disk
The following partitions are configured in the delivery state of the hard disk with Windows
Embedded Standard 2009:
Partition
1. Partition
2. Partition
Partitioning the SSD
The following partitions are configured in the delivery state of the SSD with Windows
Embedded Standard 2009:
Partition
1. Partition
2. Partition
To restore the original partition to its delivery state, it is recommended to use the software
tool SIMATIC IPC Image & Partition Creator. Detailed information about using this tool is
available in the manufacturer documentation.
114
Name Size of the card
2 GB
SYSTEM 1536 MB
DATA Remainder *
Name
system
DATA
Name
system
DATA
4 GB 8 GB
2560 MB 5120 MB
Remainder * Remainder *
Size
25 GB
Remainder
Size
15 GB
Remainder
Operating Instructions, 10/2010, A5E02368074-02
File system
NTFS
(compressed)
NTFS
(compressed)
File system
NTFS (not compressed)
NTFS (not compressed)
File system
NTFS (not compressed)
NTFS (not compressed)
SIMATIC HMI IPC577C