Van Raam Easy Rider 3 User Manual page 35

Possible malfunctions
The system cannot be switched on:
•
1. Check that the battery is attached properly.
2. Check the status of the battery. If it is empty, charge the battery.
3. If the above does not provide a solution, please contact your dealer.
If a red LED flashes on the charger, unplug the charger from the power outlet and stop
•
using the charger and battery. In such a case, contact your dealer.
Table of fault notifications in the information screen:
Fault symbol/ code
All assistance modes are
flashing
Thermometer (symbol) +
all assistance modes are
flashing.
Battery with cross (symbol)
+ all assistance modes are
flashing
Lightning bolt (symbol) +
assistance settings are
turned off
Exclamation mark (symbol)
Exclamation mark (symbol)
Active assistance mode is
flashing
Active assistance mode is
flashing
All assistance modes are
turned off.
Version 23.02
Description
Temperature
controller too high
Temperature
controller too high
No communication
with the battery
Voltage too high
Voltage too low
Controller
communication error
Electrical current too
high
Motor sensor fault
The battery is
almost empty.
Consequence/ course of action
System does provide assistance,
motor power is reduced.
System does not provide
assistance, let the controller cool
down.
System does provide assistance.
Contact your dealer.
System does not provide
assistance, voltage drops
automatically when cycling speed
is slower than maximum
assistance speed.
System does not provide
assistance, check the connection
between controller and battery.
Check how full the battery is.
System does not provide
assistance. Contact your dealer.
System does not provide
assistance. Contact your dealer.
System does provide assistance.
Contact your dealer.
Charge the battery.
35/71