The bicycle is delivered with the correct tension
on the lever. The clamping lever therefore does
not have to be loosened or tightened.
If the quick-release lever no longer clamps the
seat properly, the quick-release lever bolt [A]
must be adjusted to the correct tension. You
do this by holding the quick-release lever in
the closed position tightening the bolt [A] on
the other side with a torque wrench (max. 10
Nm). Then check the functioning. The quick-
release lever must be manually operable and
the seat must not slide when closed. If the
seat will no longer slide with an open quick-
release lever, the bolt [A] has probably been
over-tightened. If you don't have the right
tools or the knowledge, consult your dealer.
Backrest position
The backrest can be adjusted to the desired
position.
1.
Loosen the hexagon bolt [A] a few turns
with an Allen key.
2.
Adjust the backrest to the desired
position.
3.
Retighten the hexagon bolt [A].
Version 23.02
[A]
[A]
11/71