Configure Software - Campbell CR300 Series Operator's Manual

4.1

Configure Software

NOTE
When LoggerNet, PC400, or
PC200W is first run, the EZSetup
Wizard runs automatically in a new
window. If this is not the first time
the software has been run, open the
EZSetup Wizard. Do this by clicking
the Add Datalogger button (shown
on the right).
Click Next.
Select the CR300Series in the
Datalogger Type and Name list.
Give the CR300 a name, such as a
site or project name, to identify it
within your software.
Click Next.
LoggerNet and PC400 only:
Select the connection type.
Select Direct Connect.
Click Next.
If this is the first time connecting
your PC to a CR300, click Install
USB Driver... to install the USB
driver.
Watch the video for Sections 4.1 – 4.2:
To set up communications with a CR300-RF407-series
datalogger, refer to the
Spectrum Radio Option Communication Setup
CR300-Series Datalogger
CR300 QuickStart Part 2.
Datalogger RF407-Series Spread
Guide.
3